I made an island for my kitchen. It is going to be multipurpose. It is almost bar height. Most of the year it will be my “craft” station in the kitchen, hopefully keeping me a little more organized. This is not a teaser post (like some people I know). I have not finished the island/bar/craft center. I hope to finish it today.
I looked at several pieces of furniture. I did tons of measuring. This is my mom’s old dresser. I tried to make it work but it was too big.
I tried this dresser too, but I figured out that a dresser was never going to work.
This is jamie’s room. It has not changed much in the last 15 or so years. Her room is on my to do list, even though I have already tackled the dreaded orange shellacked woodwork. I never made it past the desk. I didn’t even check the other pieces of furniture in her room.
I brought the desk into the kitchen to see if it was the right size. It seemed to fit the space pretty well.
The real test was to see if it would “park” where I wanted to put it when I need it out of the middle of the kitchen floor.
Remember these legs I picked up from Joey’s booth right before the peddler’s mall closed?
This is a dry fit to see if everything is going to work. The OSB was a cull bin purchase for .51 cents.
I didn’t want the OSB to be visible so I cut a piece of luan and glued it on top of the OSB. That makes a smoother painting surface.
After I glued and nailed the luan down I attached the feet. The best way to know where to put your screws is to put the foot on top, and draw an outline. I used Gorilla Wood Glue and 2 inch drywall screws.
Now on to attaching the desk to the base.
I set the drill bit on my Kreg Jig® R3 to the correct thickness of the wood.
I also set the Kreg Jig Jr to the correct setting.
I clamped the jig to the legs of the desk and drilled. The collar on the drill bit keeps you at the perfect depth.
Pretty pocket holes! (ugly OSB) My pictures are a little out of order. I drilled the holes and did all the fitting before I attached the luan.
Here ya go!
I put screws in pocket holes on both legs, and on the front and back on the left side. If you look close, you can see I also put screws in that cleat on the inside left. I also put screws on the cleat opposite of that one. And… you KNOW I also used Gorilla Wood Glue. I put 2 1/2 inch casters on each of the feet. You can also see that I removed the trim piece that had been under the drawer section.
I put bead board on both sides and the back. None of the bead board matches. On this side, it’s actually tongue and groove.
On the back it is bead board paneling I got at jamie’s home depot cull bin. (note the lack of wood trim)
On the left side here it is some different bead board paneling. Here it is in the paint booth waiting for a coat of primer.
After I painted it I had to go BUY trim! How sad is that! I had several pieces and sizes but not enough to do the whole thing. Under the drawer you will see that I used a scrap piece of bead board to trim out the area that was left open after I removed the original trim.
Did you notice I removed the drawer above the knee hole? I wanted to make it comfortable to sit at on a bar stool. Removing that drawer made me sad, but I want to be able to store the bar stool under the table when not in use.
It basically looks like this currently. I did get the white baseboard painted with primer. I want to finish painting it today with the paint sprayer. However I’m afraid it won’t be warm enough. Regardless, I will get it painted today and show you the finished product tomorrow. Granted it may not be IN the kitchen, but it will be finished.
edited to add: Kitchen Island from a desk completed. I have now updated the island again